4-Zone 8-Speaker Pack with 6.5-Inch In-Ceiling Speakers Poly Cone BUN900029

This in ceiling speaker pack with 4 way speaker switch is used to create multiple zones in your home using your existing receiver or amplifier. 

Inwall and Ceiling Speakers
Its all about lifestyle. Large speaker enclosures in rooms sometimes look aesthetically untidy and not to mention speaker wires being stuck to the walls and architraves trying to hide those messy cables.Inwall and ceiling speakers are a beautiful alternative that look fantastic and sound exceptional. No more messy wires.

6.5" In ceiling 2 way Speakers
This 6.5" 2 way speaker utilises the wall or ceiling cavity to create a smooth base response with exceptional higher tones, and with the styling of this speaker your home will be the envy of you friends. 6.5" inch 2 way with Injected-Moulded Polypropylene Composite Cone from the edge with single swivel dome tweeter and a huge 'WOW' factor! These speakers use a larger 30mm silk dome tweeter for better sound quality than the 25mm versions commonly found in cheaper models
Designed for inwall or ceiling applications

Features:
- 6.5" Woofer with Injected-Moulded Polypropylene Composite Cone and rubber edge
- 10 oz magnet with 1" voice coil
- 30mm Swivel Silk Dome tweeter
- Impedance: 8 ohms
- Power: 100 watts maximum
- Frequency response: 100Hz - 20kHz
- Installation Dimensions (mm): 200 (diameter) x 88 D

Please note: Not suitable for environments where the air has a high salt content, such as coastal areas. For more info, please contact our helpful staff.

Uses For 4 Way Speaker Cable Selector Switch
This switch allows four pairs of speakers to be run from an amplifier with only one set of outputs, or four pairs of speakers from the one speaker cable. The switch allows you to listen to one pair, two pairs, three pairs, or all four pairs at once! The spring clip terminals accept speaker cable up to 16 AWG. 

Impedance: Prevent Damage to your Amp!
Please note that this switch can only be used with an amplifier that can operate down to 4 Ohms. If you are not sure if your amp is compatible, get in touch with us.

Impedance switching built into the unit ensures the minimum impedance seen by the amp is 4 Ohm (if using 8 Ohm speakers), no matter how many of the pairs of speakers are switched on. See chart below.

Impedance Chart
Switches on (impedance):
- 1/2/3/4 (8 Ohm)
- 1+2 (16 Ohm)
- 1+3 (4 Ohm)
- 1+4 (4 Ohm)
- 2+3 (4 Ohm)
- 2+4 (4 Ohm)
- 3+4 (16 Ohm)
- 1+2+3 (5.3 Ohm)
- 1+2+4 (5.3 Ohm)
- 1+3+4 (5.3 Ohm)
- 2+3+4 (5.3 Ohm)
- 1+2+3+4 (8 Ohm)