8 x 6.5in Selby In Ceiling Speakers Carbon Cone 100W plus 4-way Speaker Switch CS609 A1006

This in ceiling speaker pack with 4 way speaker switch is used to create multiple zones in your home using your existing receiver or amplifier. 

Inwall and Ceiling Speakers
Its all about lifestyle. Large speaker enclosures in rooms sometimes look aesthetically untidy and not to mention speaker wires being stuck to the walls and architraves trying to hide those messy cables. Inwall and ceiling speakers are a beautiful alternative that look fantastic and sound exceptional. No more messy wires.

6.5" Inwall 2 way Speakers
Sometimes known as architectural speakers, this 6.5" 2 way speaker utilises the wall or ceiling cavity to create a smooth base response with exceptional higher tones, and with the styling of this speaker your home will be the envy of you friends. 6.5" inch 2 way with carbon compound cone with rubber edge with single swivel dome tweeter and a huge 'WOW' factor! These speakers use a larger 30mm silk dome tweeter for better sound quality than the 25mm versions commonly found in cheaper models. Designed for inwall or ceiling applications 

Features:
- 6.5" Woofer with Compound Carbon Cone with rubber edge
- 10 oz magnet with 1" voice coil
- 30mm Swivel Silk Dome tweeter
- Impedance: 8 ohms
- Power: 100 watts maximum
- Frequency response: 100Hz - 20kHz
- Actual Dimensions (mm): 235mm
- Cut Out Dimensions (mm): 200 x 88 D

Please note: Not suitable for environments where the air has a high salt content, such as coastal areas. For more info, please contact our helpful staff.

Uses For 4 Way Speaker Cable Selector Switch
This switch allows four pairs of speakers to be run from an amplifier with only one set of outputs, or four pairs of speakers from the one speaker cable. The switch allows you to listen to one pair, two pairs, three pairs, or all four pairs at once! The spring clip terminals accept speaker cable up to 16 AWG. 

Impedance: Prevent Damage to your Amp!
Please note that this switch can only be used with an amplifier that can operate down to 4 Ohms. If you are not sure if your amp is compatible, get in touch with us.

Impedance switching built into the unit ensures the minimum impedance seen by the amp is 4 Ohm (if using 8 Ohm speakers), no matter how many of the pairs of speakers are switched on. See chart below.

Impedance Chart
Switches on (impedance):
- 1/2/3/4 (8 Ohm)
- 1+2 (16 Ohm)
- 1+3 (4 Ohm)
- 1+4 (4 Ohm)
- 2+3 (4 Ohm)
- 2+4 (4 Ohm)
- 3+4 (16 Ohm)
- 1+2+3 (5.3 Ohm)
- 1+2+4 (5.3 Ohm)
- 1+3+4 (5.3 Ohm)
- 2+3+4 (5.3 Ohm)
- 1+2+3+4 (8 Ohm)